Eddy Current Testing (Weld) Level 1 (RTO/EC1)




The level 1 course is a basic course in eddy current. This course required personnel to have a mid level understanding of mathematics and physics, as these are the basic of the inspection technology used. Eddy current inspection is one of the several NDT methods that use the principle of "electromagnetism" as the basis for conducting examination. Candidates on completion of the course will able to calibrate eddy current instruments and ability to understand the eddy current impedance plane response, student are trained to perform conductivity, lift off, thickness, flaw detection application and finally produce acceptable reports.


Course Content


  • History of Eddy Current Testing
  • Electrical Theory
  • Current Flow and Ohm's Law
  • Electrical Circuits
  • Magnetism
  • Alternating Current
  • Electromagnetism
  • Impedance
  • Vectors
  • Principles of Eddy Current Testing
  • Types of Inspection Coils
  • Test Coil, Arrangements
  • Eddy Current Instrument Circuits
  • Indicating Devices
  • Properties Affecting Eddy Currents


Duration: 5 days


Pre-requisites for attending this course: NONE


Special Notes


This course is intended to provide a basic knowledge of Eddy Current Testing fundamentals sufficient to enable the technician to carry out Eddy Current Testing to established procedures under the supervision of Level II or Level III personnel.


Examination Arrangement:


Contact Ruane-TATI Sdn Bhd

At (09) 8631033


Search course


PT 4847, Jalan Panchor, Teluk Kalong, 24000 Kemaman, Terengganu, Malaysia

Tel: +609 863 1033

Fax: +609 863 1034

Email: admin@ruane-tati.com